Open cabinet under a kitchen sink showing the drain pipes

Repair A Crack or Hole In A Pipe

Learn More About WaterWeld

Stop a leak in a copper, PVC or metal pipe with J-B Weld WaterWeld epoxy putty. Shut off and drain the line, sand and clean the pipe, then press the kneaded putty over the crack or hole. It cures in an hour and holds up to 500 PSI water pressure. Leave it overnight before restoring full pressure.

Difficulty
Easy
Working time
20 min
Cure time
Full cure 1 hr; overnight before full pressure
Works on
CopperPVCMetalCast iron

How to repair a crack or hole in a pipe

  1. Step 1: Shut off and drain the line

    Turn off the water supply and open a faucet to drain the pipe. Dry the area around the leak.

  2. Step 2: Sand and clean the pipe

    Sand an inch or so around the crack or hole to rough up the surface, then wipe it clean.

  3. Step 3: Cut

    Remove required amount of putty.

  4. Step 4: Mix

    Thoroughly knead putty with fingers to a uniform color.

  5. Step 5: Press it over the leak

    Press WaterWeld firmly over the crack or hole and wrap it around the pipe, extending past the damage on every side.

  6. Step 6: Cure before turning the water on

    WaterWeld cures off-white in about an hour. Wait overnight before restoring full water pressure.

What you'll need

J-B Weld products

Tools and materials

  • Gloves

Frequently asked questions

How much water pressure can a WaterWeld repair hold?

J-B Weld rates WaterWeld to withstand water pressure up to 500 PSI once fully cured, roughly ten times typical household supply pressure. That rating assumes a properly prepped repair: shut the water off, dry and sand the area, clean it, and let the putty reach full cure before restoring pressure. It is still a patch, not a replacement for a damaged section of pipe. On a supply line that has failed from corrosion or age, plan on replacing the section.

Can WaterWeld be applied to a wet surface or an active leak?

WaterWeld will set and cure underwater, but it bonds best to a dry surface. Shut off the water, dry the area, sand off any gloss, and clean it before you apply. Once the putty is pressed into place it will continue curing even if it is submerged. Wait for a full cure, at least one hour and preferably overnight on plumbing, before you restore pressure.

Is WaterWeld safe for drinking water and potable water tanks?

Yes. WaterWeld is certified to NSF/ANSI/CAN 61, the standard for drinking water system components, under J-B Weld Company LLC's NSF listing. That covers potable water pipes and fittings; NSF's listing limits exposed sealant surface area to 1.3 sq cm per litre (0.2 sq in per litre), which a normal patch on a pipe is well inside. Let it cure fully before restoring flow. The certification covers drinking water safety specifically, not food contact.

Other repairs using WaterWeld Epoxy Putty

NEED HELP FINDING THE RIGHT PRODUCT FOR YOUR PROJECT

FIND YOUR FIX