Gray dresser drawers with brass drawer pulls

Repair Stripped Screw on a Drawer Pull

Learn more about KwikWood

When a drawer pull spins or falls off, the screw hole is usually stripped. Pack the hole with J-B Weld KwikWood epoxy putty, reset the screw and reattach the pull. KwikWood sets in about an hour and grips the screw like new wood, so the pull stays tight.

Difficulty
Easy
Working time
15 min
Cure time
Sets in 1 hr
Works on
Wood

How to repair stripped screw on a drawer pull

  1. Step 1: Clean the hole

    Remove the pull and screw. Clear dust and loose wood fibers out of the stripped hole.

  2. Step 2: Cut

    Remove required amount of putty.

  3. Step 3: Mix

    Thoroughly knead putty with fingers to a uniform color.

  4. Step 4: Pack the screw hole

    Press KwikWood into the stripped hole and around the screw threads.

  5. Step 5: Reattach and let cure

    Insert the screw, attach the drawer pull and wipe away any excess putty. Let it cure for about an hour before using the drawer.

What you'll need

J-B Weld products

Tools and materials

  • Drawer pull
  • Drawer
  • Gloves
  • Knife

Frequently asked questions

Can KwikWood be sanded and drilled, and does it shrink?

Yes. KwikWood sets in 15 to 25 minutes and cures in about an hour, after which it can be sanded, drilled, tapped, filed, machined and painted. It cures tan and has a tensile strength of 2450 PSI. It does not expand or shrink as it cures and will not rot or crack. For a hole you intend to redrill, let it cure fully first.

How long do you have to work with KwikWood after mixing it?

You get roughly 15 to 25 minutes of working time once the two parts are kneaded to a uniform color, and it is hard in about an hour. There is no reliable way to extend that. Adding a few drops of acetone will keep it pliable longer but can weaken the cured putty. For a large repair, mix and apply in smaller batches instead.

Can KwikWood be used to glue two pieces of wood together?

KwikWood is a filler, not an adhesive, so it is not the right choice for joining boards or closing a split that carries load. Use wood glue and clamps for that, or Original J-B Weld (8265) on bare, unfinished wood where you need more strength. KwikWood is for filling gouges, holes, rot pockets, missing edges and screw holes.

Other repairs using KwikWood Epoxy Putty

NEED HELP FINDING THE RIGHT PRODUCT FOR YOUR PROJECT

FIND YOUR FIX